TruMH

GENERAL

• HUD Code
• 20 lb. Roof Load Std., 30 psf optional
• Thermal Zone 1 Std., zones 2 and 3 optional
• Wind Zone 1 Std., zones 2 and 3 optional

FRAME

• I - Beam: 12” or 10” model specific
• Outriggers: 96” spacing
• Crossmembers: 96” spacing
• Header: (Front/Rear) Flush, not recessed
• Axles: Spread (no equalizers) overslung mounted
• Brake Axles: One, except where more are mandatory by state DOT
• Hitch Beam: 8” Detachable Hitch

FLOOR

• Joists: 2x6 / 19.2” o.c.
• Carpet: Factory Select
• Carpet Bar: None
• Pad: 3.5 lb. (minimum) Rebond Pad
• Vinyl: Factory Select
• Decking: 19/32” 4x8 OSB T&G

EXTERIOR (7'-0" SIDEWALLS, 7'-0" ENDWALLS)

• Vinyl Siding: Standard
• Sheathing: WZ 1 - Foam standard, plant specific brand. WZ 2 & 3
• Includes OSB
• House Wrap: Over OSB (where used)
• Shutters: None

WINDOWS AND DOORS

• Front door: Out swing 34” x 76” blank, no storm.
• Rear door: Out swing 32” x 76” blank, no storm.
• Interior doors: Factory Select
• Windows: Metal single glaze, size per prints.
• Metal storm windows for thermal zone 2 and 3 only.

ROOF / CEILING

• Design Load: 20 psf Live load standard, 30 psf options where needed
• Shingles: 20 year
• Trusses: 24” o.c. spacing
• Sheathing: 7/16” OSB
• Insulation: Blown Fiberglass
• Ceiling: Textured
• Ceiling Slope: Vault/Flat Ceiling
• Attic Ventilation: Pot vents (low), Ridge vent high

PLUMBING

• Water Heater: 30 gallon electric
• Kitchen Sink: Stainless Steel, dbl bowl
• Lavatory Sinks: Plastic
• Faucets: Plastic
• Master Bath: 54 ABS Plastic Tub
• Hall Bath: 54 ABS Plastic Tub

HVAC

• Heat: Electric (gas optional).
• Ductwork: Metal duct
• Thermostat: 8 Wire

ELECTRICAL

• Load Center: 200 amp
  (100 amp allowed when gas option ordered – gas range and gas furnace).
• Exterior Receptacles and Switches: (1) GFI recept and cover.
• Interior Receptacles and Switches: White, self contained
• Phone Jack(s): None
• AC: Conduit

WALLS

• Exterior Wall Construction: 2x4, 16” O.C. spacing
• Ext. Wall Height Sidewall = 7’-0”, Endwall = 7'-0"
  (combo vault/flat ceiling, per prints)
• Interior Wall Construction: 2x3, 24” O.C. spacing
• Wall Coverings: 5/16” minimum VOG or paper on gyp
• Wall Coverage at Closets: 5/16” gyp, raw

INTERIOR FEATURES

• Cabinets: MDF / 24” tall overheads.
• Countertops (All): Formica
• Backsplash: None
• Closet Shelving: Closet Maid – vinyl wrapped metal.
• Utility Shelving: None
• Refrigerator: 18 CF
• Range: Electric
• Range Hood: 30”, 100 cfm min, vent through sidewall.
• Valance on LR windows only. No mini blinds